Contents

Apple iPhone: How to fix dents on the case

Have you dropped your iPhone and got a pretty bad dent on the aluminum casing? Well, here’s how to fix it yourself. If you dare try.

You carry your iPhone almost everywhere with you, and that leaves the smooth body of the phone susceptible to damage. Dents and dings in the metal backing are especially possible if you leave it unprotected in your pocket or purse with other hard or sharp objects. However, there’s no reason to rush out and get a new phone if a few dents do show up. You can pop out dents and leave the surface smooth once again.

  1. Turn off the iPhone. This prevents any damage to the phone and potential harm to yourself.

  2. Unscrew the two screws on the top and bottom edges of the iPhone with a small screwdriver. Slide the dented metal back casing about a quarter of an inch. Pull the case from the phone and place it to the side with the screws in a safe place.

  3. Wrap a towel or rag around the case. This protects it from further damage while removing the dents that already exist.

  4. Place the case on a flat surface with the high parts of the dents facing upward.

  5. Tap the dented areas with the hammer until they are flush with the rest of the case surface. Start gently at first and increase the intensity of each tap as needed. Too much force will create more dents in the opposite direction.

  6. Remove the towel or rag from the case and examine the surface for any remaining dents. Repeat the covering and hammering process until all of the dents are gone and the surface of the case is smooth.

  7. Replace the case on the back of the iPhone and slide it into place until you hear a clicking noise. Insert and screw in each of the two screws on the top and bottom edges of the phone. You can now turn on the iPhone once again.

SYDNEY CBD REPAIR CENTRE IS OPEN 6 DAYS A WEEK

Weekdays: 10am – 6pm
Saturday: 10am – 6pm
Sunday : Closed

After Business Hours, By Appointment only.

CALL 8011 4119 or 043 777 4119
[email protected]